FDI-01 Falling Dart Impact Tes…

FDI-01 Falling Dart Impact Tester
is applicable in the impact result and energy measurement 

of the falling dart
from a certain height against plastic films and sheets with a thickness less 

than1mm, which
would result in 50% tested specimen failure.

 >  CHARACTERISTICS

      * Micro-computer calculation, LCD display and Manu interface;

      * Two test methods integration: A & B.

      * Built-in observation light;

      * Pneumatic specimen clamp and release;

      * Falling dart electromagnetic suspension and automatic release;

      * Two start modes: Manual and foot-pedal;

      * Automatic testing status judgment;

      * Multi-units result display and printing;

      * Mini-printer;

      * RS232 interface;

 >  PRINCIPLE

      At the beginning of the test, choose test method, and
estimate an initial mass and Δm. Start test. 

      If the first specimen fails,
decrease the mass of the falling dart by decreasing weight of Δm. If the 

      first
specimen is not a failure, add the mass of the falling dart by increasing
weight of Δm. Test as 

      the same. In brief, increase or decrease the Δm according
to whether the former specimen is a 

      failure or not. After 20 specimens,
calculate the total number of failure specimens N. If N equals to 

      10, test
over. If N is less than 10, add specimen and continue to test until N is equal
to 10. If N is 

      more than 10, add specimen and continue the test until the
number of non-failure specimen is 10. 

      Then the tester calculates the test
results automatically. according to special formula. 

 >  TECHNICAL INDEXES

      Test Method: A, B (Optional)

      Test Range: method A: 50~2000g  

                          method B: 300~2000g

      Accuracy:0.1g(0.1J)

      Specimen Clamping: pneumatic

      Gas Source Pressure: 0.6MPa (Users provide gas source
themselves)

      Inlet Size: Ф8mmpolyurethane pipe

      Specimen Size: >150mmx150mm

      Power: AC 220V 50Hz

      Net weight:70kg

 >  STANDARDS

      ASTM D1709, ISO 7765, JIS K7124

 >  CONFIGURATION 

      Standard:method A configuration, mini-printer

      Optional:method B configuration, professional software,
communication cable

Please Note:

Pictures used are for illustration purposes only and may differ from the actual product received.

We are always dedicated to the innovation and improvement of product performance and function.

Therefore, technical specifications are subject to change without further notice.

Shinetime International and Leading Instruments reserve the rights of final interpretation and revision.